CONINVERS®

Assembly Instructions

●  RC-Connectors style T, N  ●

Slide endbell (1) and with the seal elements (2,3,4) plus the elbow over the jacket.

Strip the jacket about 70 mm (2.7 inches).

For versions with additional cable glands please slide them over the jacket as the first item.

Shielding sleeve version:

Bend shielding braid back at a right angle then push the shielding sleeve over the plastic (or cotton)

foil, but under the shielding braid in twisting motion, between braid and wire bundle.

Next, cut the extended shielding braid flush along the outer diameter of the end of the shielding

sleeve (4A).

Shielding disc version:

Bend shielding braid back at a right angle and cut it flush along the outer diameter of the shielding

disc (4B).

Unshielded vesion:

Remove foil, inner insulation, etc. to expose just the single wires (4C).

Assy.

Strip the wire ends 3.5 mm, twist and pre-tin the ends to solder, or leave alone for crimping purposes.

Instr.

Solder, screw or crimp the wires to the contacts of the connector insert.

Fold plastic cover (6) over the wires as shown.

Push insert (7) with the cover (6) into the front unit (8) while aligning the desired

coding channel of the insert with the coding rib inside of the unit. Insert the front unit into the right-angled

connector shell and tighten with nut (8A).

Press cable with shielding/sealing elements into the back side of the angled connector.

Screw the endbell tight to the stop.

If you use versions with other cable glands in addition, screw them in as the last item.