| CONINVERS® |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Assembly
Instructions |
|
|
|
| ● RC-Connectors style 1,
7, L, J, 3, U, G, P ● |
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| Slide
cable gland (1) with endbell (2) and coupling nut (3) over the jacket of the
cable. |
|
|
|
|
| Some versions may have no
coupling nut. |
|
|
|
|
| |
|
|
|
|
| Strip
the cable jacket back 23 mm (0.9 inches). |
|
|
|
|
| |
|
|
|
|
|
|
| Remove
foil and inner insulation material to expose the cable wires. |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| Strip
the wire ends 3.5 mm and twist the strands for pre-soldering, if you use
solder connector |
|
|
|
|
|
| inserts. |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| Solder,
screw or crimp the wires to the contacts of the connector insert. |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| Fold
plastic cover over the wires and the connector insert as shown. |
|
|
|
Assy. |
|
|
| |
|
|
|
Instr. |
|
|
| Push
the connector insert, including the plastic cover, into the enclosure (6)
while aligning |
|
|
|
|
|
| the coding channel with the
coding rib. |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| Screw the endbell tight to the
stop. |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| Screw in the desired
cable gland (if used). |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
