Mounting instructions for cables
	1	Cable on coils should only be unrolled from the outside layer.
		Schleppflex cable should be installed in the cable chain
		without any torsion on the cable.
		The cable should not be twisted in any way.
	2	Cabel on spools should be unreeled from the spool in order
		to avoid kinks. Therefore, avoid placing the cable in loops
		over the flange of the spool. We recommend to
		install the cable torsion free into the cable chain immediately
		after cutting the cable at the required length. If it is necessary
		to stock a precut length, the cable sould be stocked streched.
		Axial twisting of the cable must definitely be avoided at all times.
	3	Chain cables have to be installed loosely in the cable chain,
		that is, without any restraint in the cable chains. Various cables
		in the cable chain should be separated by separators. The size
		of the cable chain should be such that they allow for sufficient
		space for cable movement.
	4	The connection, i.e. the fixation point of the cable on each side of
		the cable chain, should be at least 30 x the cable diameter from
		the bending point of the chain. Stress on the fixation point has
		to be avoided. The strain relief should be applied over a large
		area of the outer sheath. Squeezing the conductors of the cable
		will shorten the service life of the cable. In any case, the cable
		can never be moved all the way to the connection point.
	5	In case of a shielded cable we recommend you fasten the shield
		by means of a cable tie in order to avoid dislocation or
		migration of the shield.
	6	If one of the cables in the cable chain is defective, all cables
		should be replaced, as otherwise deviations of quality could
		occur due to mechanical stress.